Showing 1 - 6 of 6 , query time: 0.01s
Cover Image
Format:
Image
Standing above the cavern in the Gilman mine where the ball and rod mills are housed. The mills are on an incline for gravity feed down to the loading docks. At the center right of the photo, steel rods are stacked for use in the rod mill.
Cover Image
Format:
Image
At 16 level, the ore train would dump rock into the large pit (Grizzly) at the bottom of which was located a jaw crusher. The crusher would send the ore into the ball mill and rod mill where the ore was pulverized to a fine powder. Inside the ball mill, there would be ore and steel balls, approximately 10 in. in diameter. As the mill rotated, the ore was crushed by the balls. Eventually, the balls would wear down and Bob Riggle remembers his dad...
Cover Image
Format:
Image
At right is the ball mill. At left is the rod mill. The mills are on an incline for gravity feed down to the loading docks. At the center right of the photo, steel rods are stacked for use in the rod mill.
Cover Image
Format:
Image
Secondary or fine crusher used in the milling process at Gilman.
Cover Image
Format:
Image
Electrically activated shaft weights in the mill section at Gilman Mine.
Cover Image
Format:
Image
The rod and ball mill. The rod mill is on the left and ball mill on the right. These were used to grind the zinc concentrates for additional chemical processing. Prior to this, the material had chemical agents added to allow the zinc mineral surface to adhere to flotation bubbles. These were some of the steps for making the zinc ready to ship in railroad cars.