Gilman Mine, Gilman, Colorado
Showing
121 - 125
of 125
, query time: 0.01s
Format:
Image
Harold Steinmeyer (left) and Bill May in the compressor room at Belden. Prior to the electrical power plant at Gilman, much of the electricity for the mine (compressors) was supplied by the use of Pelton wheels (turbines) powered by the water from Fall Creek at Belden.
122) Tailings pond
Format:
Image
The tailings pond below Gilman (south east of Maloit Park). Mine wastes were piped approximately four miles down into the settlement area. The tailings pond kept mine wastes from flowing into the Eagle River.
Format:
Image
Conveyor unloading zinc from the dryer at Belden. The zinc was then taken to the loading tippel to be loaded on railcars. Durbin McIlnay is monitoring the process.
Format:
Image
Tearing down the existing tailings pipe and stands at the tailings pond below Gilman. Once enough sediment had been released through the bottom of the pipe, new stands were erected to lift the pipe to a higher elevation. Harv Collins is in the center of the photo wearing light colored coveralls.
Format:
Image
New section of pipe and stands for the tailings pond. Trusses with new sections of pipe are being built. Later a safety cable was added along a catwalk , which was used by employees to remove the plugs in the pipe and drain the tailings. Tailings were piped from Gilman as a slurry and, as the slurry dried, it became the same consistency as a fine sand.
