Belden, Colorado
Showing
1 - 20
of 63
, query time: 0.09s
Format:
Image
Standing above the cavern in the Gilman mine where the ball and rod mills are housed. The mills are on an incline for gravity feed down to the loading docks.
At the center right of the photo, steel rods are stacked for use in the rod mill.
2) Repair shop
Format:
Image
Beth McIlnay, Lucille Riggle and Everett Limatta (far right) are standing in the repair shop in the Gilman mine.
4) Belden
Format:
Image
A close-up of facilities at Belden, some abandoned. Across the Eagle River, the power plant is visible at left.
Format:
Image
Lucille Riggle is seated at Bob Riggle's desk in the warehouse. Bill Burnett is at left rear; Alberta Limatta is at far right.
Format:
Image
The 10 x 10 in. timbers above the tour group show a typical means of support in a drift. These timbers are probably from the Fleming Lumber Co. in Red Cliff, which produced a great deal of mine timber.
Format:
Image
A view of Belden in the snow [1930s] with mine facilities. A man and a dog are walking the railroad tracks; the Eagle River is almost frozen over.
10) Repair area
Format:
Image
From far left: Chuck Colby, Berniece Chadwick and Davy Burnett. Jean Flaherty is at far right.
11) Belden
Format:
Image
Facilities at Belden, some abandoned. Mine buildings are at right, midfield. The Eagle River is at the right and railroad tracks are at the bottom
13) Loading tipple
Format:
Image
The loading tipple is at far left where products would be transferred to railroad cars for shipment. The "Bull Gang" managed loading and maintenance in the Eagle River canyon. Robert E. Riggle was Bull Gang chief at one point.
The stairway at center goes into a mine entrance at about the 17 level. There are 80 feet between levels in the Gilman mine.
Format:
Image
The lathes were for working steel. They could straighten bent drill steel, put new ends on the rods and send them back for reuse. The Gilman shop reused as much equipment and supplies as was possible.
Format:
Image
At 16 level, the ore train would dump rock into the large pit (Grizzly) at the bottom of which was located a jaw crusher. The crusher would send the ore into the ball mill and rod mill where the ore was pulverized to a fine powder.
Inside the ball mill, there would be ore and steel balls, approximately 10 in. in diameter. As the mill rotated, the ore was crushed by the balls. Eventually, the balls would wear down and Bob Riggle remembers his dad...
Format:
Image
This is the bottom of 18 level where water has been allowed to infiltrate the lower levels beneath it.
Format:
Image
Service tram going from upper level, Gilman, to Belden in Eagle River Canyon. Cribbings visible, holding hillside in place. Train tracks in foreground.
[Title supplied from catalog prepared by the Eagle County Historical Society.]
20) Belden
Format:
Image
Facilities at Belden, some abandoned. Gilman is visible at the top of the cliff. Mine buildings are at right, midfield.
